EUTECH INSTRUMENTS ECOSCAN TEMP JKT PORTABLE METER Manuale delle Istruzioni Scaricare il pdf (Pagina 8)

2.5 Battery Replacement

A “LO” annunciator in the LCD alerts you when battery power is running low.

Replace with the same type as recommended by the manufacturer.

Figure 5: Low battery indicator

Caution: Power off the meter when changing battery.

2.6 Connecting the Temperature Sensor

Insert the 2-pin mini connector plug of the temperature sensor into the connector

socket on the side of the meter.

NOTE: The negative pin is larger than the positive pin, be sure to properly align the

pins. Unplug the sensor when not in use.

Figure 6: Connecting the temperature sensor

2.7 Switching the Meter On

1. Press ON/OFF key to power up your meter. All

the LCD segments display momentarily as the

meter performs a self-diagnostic test, per shown

in section 2.2. The LCD then switches into

measurement mode.

2. The LCD displays “oPEn” if the temperature sensor is faulty, or there is an

open circuit. Please refer to section on Troubleshooting if in doubt.

Figure 7: "Open"

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Nessun commento

EUTECH INSTRUMENTS ECOSCAN TEMP JKT PORTABLE METER Manuale delle Istruzioni Pagina 8